Kenmore elite he5t washer repair manual

Kenmore Elite He5t showing Suds and F35

I still get the suds/ F35 error rht at startup after the initial drain. i am sorry you are having a problem with your kenmore 110.47789701 front load washer. you can access the pressuer switch by removing the top panel. you can also have the problem checked and repaired in your home by a sears cian.

Most Recent Kenmore Elite HE5t Washer

When I do the steamer diagnostic by holding start and the steam button I get a yes indicating that the steamer is working. I am kind of narrowing it down to the steamer assembly or the valve that opens to fill the steamer. here is the link: sears home services washer repair.

<b>Kenmore</b>-<b>Elite</b> <b>Washer</b> Replacement Parts &

Getting F35 error code on my kenmore elite

I ran the diagnostic and it makes it through the C:00 test fine and then throws a F35 error before it gets to the C:01 test. I read somewhere to check the flow meter and that spins just fine. Is there something else I could check, the Control board is very expensive?

Kenmore Elite Washer Manual Download -

I have now replaced the pressure switch and the steamer control board. Reading this site I noticed other people having the same problem, but no solutions were stated. Posted August 10, 2013 thank you for your question. if you do not see an excessive amount of suds then the error is likely caused by a bad pressure switch.


Kenmore elite he5t washer repair manual:

Rating: 90 / 100

Overall: 99 Rates